Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > DIAGNOSIS SYSTEM

for Preparation Click here



CHECK INDICATOR (for LCD Type)
  1. Turn the ignition switch ON.



  2. E280128E01
  3. Check that the cruise control indicator light illuminates when the cruise control main switch is turned ON, and that the indicator light turns off when the main switch is turned OFF. If the results are not as specified, inspect the cruise control indicator light circuit (Click here).

    HINT:
    BE04034E71
    While driving with cruise control, the ECM activates AUTO CANCEL of the cruise control system when a malfunction in one of the following occurs: vehicle speed sensors, stop light switch or other related parts. When AUTO CANCEL is activated, the cruise control indicator outputs the blinking pattern shown in the illustration. At the same time, data of the malfunction is stored as a DTC.


CHECK INDICATOR (for TFT Type)


    E280127E01
  1. When a malfunction occurs in the cruise control system, the system turns off the cruise control indicator and the master warning light illuminates at the same time a "pong" sound is heard. Also, cruise control indicator light is displayed in the multi-information display and the ECM stores DTCs.

    HINT:
    1. If the system returns to normal, the cruise control indicator light message on the multi-information display disappears.
    2. Do not remove fuses or disconnect the battery cables until the inspection is finished. Otherwise, the data stored in the ECM will be cleared.