Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL SYSTEM

CRUISE CONTROL SYSTEM > Cruise Main Indicator Light Circuit

for Preparation Click here


DESCRIPTION

  1. The ECM detects a cruise control switch signal and sends it to the combination meter via CAN. Then the cruise control indicator light comes on.
  2. The cruise control indicator light circuit uses CAN for communication. If there is a malfunction in this circuit, check for DTCs in the CAN communication system before troubleshooting this circuit.

INSPECTION PROCEDURE

NOTICE:
First perform the communication function inspections in How to Proceed with Troubleshooting to confirm that there are no CAN communication malfunctions before troubleshooting this problem.

1.PERFORM ACTIVE TEST USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)
  1. Using the Techstream, perform the Active Test (Click here).

    Combination Meter 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Indicat. Lamp Cruise
    Cruise control indicator light operation
    OFF or ON
    -

    OK:
    Indicator light comes on / goes off.



NG
GO TO METER / GAUGE SYSTEM (Click here)
OK


2.READ VALUE USING TECHSTREAM (CRUISE CONTROL INDICATOR LIGHT)
  1. Using the Techstream, read the Data List (Click here).

    Cruise Control 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    CCS Indicator M-CPU
    Cruise control indicator light (Main CPU) / ON or OFF
    ON: Cruise control indicator light is ON
    OFF: Cruise control indicator light is OFF
    -

    OK:
    When cruise control main switch operation is performed, the result will be same as above.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for 1UR-FE)
    B
    NG (for 1GR-FE)
    C
    NG (for 3UR-FE)
    D
    NG (for 3UR-FBE)
    E



B
REPLACE ECM (Click here)

C
REPLACE ECM (Click here)

D
REPLACE ECM (Click here)

E
REPLACE ECM (Click here)
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)