AUDIO AND VISUAL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
| What | Vehicle model, system name |
| When | Date, time, occurrence frequency |
| Where | Road conditions |
| Under what conditions? | Driving conditions, weather conditions |
| How did it happen? | Problem symptoms |
| |||||
| 3.INSPECT BATTERY VOLTAGE |
Measure the battery voltage.
| |||||
| 4.CHECK CABIN |
Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.
|
| ||||
| |||||
| 5.CHECK FOR DTC |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs.
Recheck for DTCs by simulating the operation indicated by the DTCs.
| Result | Proceed to |
| DTC is output again | A |
| DTC is not output | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to the Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 7.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM |
Terminals of ECU (Click here).
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.RECHECK FOR DIAGNOSTIC TROUBLE CODE |
| |||||
| 10.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|