Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Illumination for Panel Switch does not Come on with Tail Switch ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)
E278187
  1. Enter the "Vehicle Signal Check Mode" screen. [Refer to Check Vehicle Signal in Operation Check (Click here)]

  1. Check that the display for "TAIL" changes between ON and OFF according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or head
    ON
    Off
    OFF

    HINT:
    This display is updated once per second. As a result, it is normal for the display to lag behind the actual switch operation.

  1. Check that the display for "ADIM/TCAN" changes between DIM and BRIGHT according to the light control switch operation.

    OK:
    Light Control Switch
    Display
    Tail or head
    DIM
    Off
    BRIGHT

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
A

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)