Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Voice is not Recognized

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK CONDITION
  1. Check if the system voice recognition level is low when recognizing a particular voice.
    Result 
    Result
    Proceed to
    System voice recognition level is low with any voice
    A
    System voice recognition level is low only for a particular voice
    B

    HINT:
    System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.



B
END (RECOGNITION BY PARTICULAR VOICE)
A


2.CHECK MICROPHONE AND VOICE RECOGNITION (OPERATION CHECK)


    E268457
  1. Enter the "Microphone Check" screen. [Refer to Check Mic&Voice Recognition in Operation Check (Click here)]

  1. When voice is input into the microphone, check that the microphone input level meter changes according to the input voice.

  1. Push the recording switch and perform voice recording.

    1. Select the recording switch with the blower motor of the air conditioning system stopped. If an outlet of the air conditioning system is facing the microphone, noise may be recorded.
    2. Voice can be recorded for up to 5 seconds.

  1. Check that the recording indicator remains on while recording and that the recorded voice is played normally without noise or distortion.

    OK:
    All check results are normal.

    Result 
    Result
    Proceed to
    OK (for Column Shift Type)
    A
    OK (for Floor Shift Type)
    B
    NG
    C



B
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)

C
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
A

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)