Home › ENGINE ยท 1GR-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the fuel injector assembly (Click here).



1. INSTALL FUEL INJECTOR ASSEMBLY

HINT:
Perform "Inspection After Repairs" after replacing the fuel injector assembly (Click here).



    A223045E01
  1. Install a new insulator to each fuel injector.
    Text in Illustration 
    *1
    New Insulator
    *2
    New O-Ring

  1. Apply a light coat of spindle oil or gasoline to new O-rings and install one to each fuel injector.



  1. Install the 6 injectors.



      A223046E01
    1. While turning each fuel injector left and right, install it to the fuel delivery pipe.
      Text in Illustration 
      *1
      Connector
      V100135
      Outward
      V100136
      Turn
      V100137
      Push

    2. Position the fuel injectors with the connectors facing outward.



2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY
  1. Place the fuel delivery pipe together with the 6 fuel injectors on the intake manifold.

  1. Temporarily install the 4 bolts, which are used to hold the fuel delivery pipe in place, to the intake manifold.



    A239745
  1. Check that the fuel injectors rotate smoothly.
    Text in Illustration 
    V100135
    Turn
    If a fuel injector does not rotate smoothly, replace its O-ring.

  1. Position the fuel injectors with the connectors facing outward.

  1. Tighten the 4 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the 6 fuel injector connectors.



3. CONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY
  1. Connect the No. 2 fuel pipe sub-assembly (Click here).



4. CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
  1. Connect the No. 1 fuel pipe sub-assembly (Click here).



5. CONNECT WIRE HARNESS
  1. Attach the 3 wire harness clamps.

  1. Connect the engine coolant temperature sensor connector.



6. INSTALL INTAKE AIR SURGE TANK
(Click here)


7. INSPECT FOR FUEL LEAK
  1. Make sure that there are no fuel leaks after performing maintenance on the fuel system.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON and turn the Techstream on.

      NOTICE:
      Do not start the engine.

    3. Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

    4. Check that there are no leaks from the fuel system.
      If there are fuel leaks, repair or replace parts as necessary.

    5. Turn the ignition switch off.

    6. Disconnect the Techstream from the DLC3.