FUEL INJECTOR > INSTALLATION |
| 1. INSTALL FUEL INJECTOR ASSEMBLY |
![]() |
Attach the 3 clamps to install the No. 6 wire harness to the delivery pipe RH.
![]() |
Attach the 3 clamps to install the No. 7 wire harness to the delivery pipe LH.
![]() |
Apply gasoline or spindle oil to a new O-ring and install it to the injector.
![]() |
Connect the injector connector.
![]() |
Install the injector to the delivery pipe as shown in the illustration.
![]() |
Check that each injector is installed to the delivery pipe facing the direction shown in the illustration.
| 2. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY LH |
![]() |
Install the 2 delivery pipe spacers and 4 insulators to the cylinder head LH.
Install the delivery pipe (with injectors) to the cylinder head LH.
Install the 2 bolts.
![]() |
Connect the No. 7 wire harness connector.
Install the No. 1 engine cover sub-assembly.
| 3. INSTALL FUEL DELIVERY PIPE SUB-ASSEMBLY RH |
![]() |
Install the 2 delivery pipe spacers and 4 insulators to the cylinder head RH.
Install the delivery pipe (with injectors) to the cylinder head RH.
Install the 2 bolts.
![]() |
Install the No. 3 engine cover.
![]() |
Connect the No. 6 wire harness connector.
Connect the ventilation hose.
| 4. CONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Connect the No. 1 fuel pipe sub-assembly to the fuel delivery pipe LH (for quick type B) (Click here).
Attach the clamp.
| 5. CONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Connect the fuel tube to the delivery pipe LH (for quick type A) (Click here).
![]() |
Connect the fuel tube to the delivery pipe RH (for quick type A) (Click here).
| 6. CONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY |
![]() |
Connect the No. 2 fuel tube to the fuel pressure regulator (for quick type A) (Click here).
| 7. INSTALL AIR CLEANER HOSE ASSEMBLY |
Install the air cleaner hose assembly with the 2 hose clamps.
Connect the vacuum hose to the air cleaner hose assembly.
Connect the ventilation hose to the air cleaner hose assembly, and slide the clamp to secure the hose.
| 8. INSTALL V-BANK COVER |
![]() |
Attach the 2 V-bank cover hooks to the No. 1 V-bank cover bracket. Then align the 2 V-bank cover grommets with the 2 pins, and press down on the V-bank cover sub-assembly to attach the pins.
| *1 | V-bank Cover Grommet |
| *2 | Pin |
| *3 | No. 1 V-bank Cover Bracket |
| *4 | V-bank Cover Hook |
| 9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 10. INSPECT FOR FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and Techstream main switch on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.