FUEL INJECTOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
Disconnect the fuel pump ECU connector (Click here).
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch off.
Crank the engine again, and then check that the engine does not start.
Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.
Connect the fuel pump ECU connector (Click here).
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
| 4. REMOVE EGR VALVE BRACKET |
| 5. DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the No. 2 fuel tube sub-assembly from the fuel pressure regulator assembly (for Quick Type A) (Click here).
| 6. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly RH (for Quick Type A) (Click here).
![]() |
Disconnect the fuel tube sub-assembly from the fuel delivery pipe sub-assembly LH (for Quick Type A) (Click here).
| 7. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Detach the clamp.
Disconnect the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly LH (for Quick Type B) (Click here).
| 8. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY RH |
Disconnect the No. 6 wire harness connector.
![]() |
Remove the 2 bolts and fuel delivery pipe sub-assembly RH.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head sub-assembly RH.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY LH |
Disconnect the No. 7 wire harness connector.
![]() |
Remove the 2 bolts and fuel delivery pipe sub-assembly LH.
Remove the 2 delivery pipe spacers and 4 insulators from the cylinder head sub-assembly LH.
| 10. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Remove the fuel injector assembly from the fuel delivery pipe sub-assembly, and then disconnect the injector connector.
![]() |
![]() |
Remove the O-ring from the fuel injector assembly.
![]() |
Detach the 3 clamps and then remove the No. 6 wire harness from the fuel delivery pipe sub-assembly RH.
![]() |
Detach the 3 clamps and then remove the No. 7 wire harness from the fuel delivery pipe sub-assembly LH.