DTC P2610 ECM / PCM Internal Engine Off Timer Performance |
| DTC No. | Monitoring Item | Malfunction Detection Condition | Trouble Area | Detection Timing | Detection Logic |
| P2610 | Soak timer (built into ECM) | ECM internal malfunction (2 trip detection logic) | ECM | Engine running | 2 trip |

| Required Sensors/Components | ECM |
| Frequency of Operation | Once per driving cycle |
| Duration | 2 times: Case 1 -: Case 2 and 3 |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not stored | None |
| All of the following conditions are met | - |
| Battery voltage | 8 V or higher |
| Ignition switch | OFF |
| CPU clock elapsed time | 1.96608 seconds or more |
| All of the following conditions are met | - |
| Internal engine off timer (elapsed time from engine stop) | 10 minutes or more, and less than 30 minutes |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |
| All of the following conditions are met | - |
| Internal engine off timer (elapsed time from engine stop) | 40 minutes or more |
| Battery voltage | 8 V or higher |
| Ignition switch | ON |
| Starter | OFF |
| One of the following conditions is met | Condition A, B or C |
| A. Both of the following conditions are met | Condition (a) and (b) |
| (a) CPU clock elapsed time | 1.96608 seconds or more, and less than 8.323072 seconds |
| (b) Internal Engine off timer | 9.375 seconds or more |
| B. Both of the following conditions are met | Condition (c) and (d) |
| (c) CPU clock elapsed time | 8.323072 to 10.420224 seconds |
| (d) Internal Engine off timer | 18.75 seconds or more |
| C. Both of the following conditions are met | Condition (e) and (f) |
| (e) CPU clock elapsed time | More than 10.420224 seconds |
| (f) Internal Engine off timer | Less than 9.375 seconds |
| ECM started by internal engine off timer last trip | Yes |
| ECM started by internal engine off timer last trip | No |
| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.REPLACE ECM |
Replace the ECM (Click here).
| NEXT | |
| 2.CHECK WHETHER DTC OUTPUT RECURS |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Clear DTCs (Click here).
Start the engine and wait for 10 minutes or more.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes / Pending.
If no pending DTC is displayed, the repair has been successfully completed.
| NEXT | ||
| ||