Home › ENGINE ยท 1GR-FE › FUEL › FUEL PRESSURE PULSATION DAMPER

FUEL PRESSURE PULSATION DAMPER > REMOVAL

for Preparation Click here



1. DISCHARGE FUEL SYSTEM PRESSURE
(Click here)


2. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



4. REMOVE INTAKE AIR SURGE TANK
(Click here)


5. DISCONNECT WIRE HARNESS


    A239472
  1. Disconnect the engine coolant temperature sensor connector.

  1. Detach the 3 wire harness clamps and disconnect the wire harness.



6. REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY


    A239749
  1. Remove the fuel pressure regulator holder.

  1. Pull the fuel pressure pulsation damper out of the fuel delivery pipe.

  1. Remove the O-ring from the fuel pressure pulsation damper.