DTC P0724 Brake Switch "B" Circuit High |
| DTC Code | DTC Detection Condition | Trouble Area |
| P0724 | Stop light switch remains ON even when vehicle is driven in GO (30 km/h (18.65 mph) or more) and STOP (less than 3 km/h (1.86 mph)) pattern 5 times (2 trip detection logic) |
|
| Related DTCs | P0724: Stop light switch/Range check/Rationality |
| Required sensors/Components | Stop light switch, Vehicle speed sensor |
| Frequency of operation | Continuous |
| Duration | GO and STOP 5 times |
| MIL operation | 2 driving cycles |
| Sequence of operation | None |
| The monitor will run whenever this DTC is not present. | None |
| Battery voltage | 8 V or more |
| Starter | OFF |
| Ignition switch | ON |
| GO: Vehicle speed | 30 km/h (18.65 mph) or more |
| STOP: Vehicle speed | Less than 3 km/h (1.86 mph) |
| Brake switch | Stuck ON |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| Item | Measurement Item/ Range (Display) | Normal Condition | Diagnostic Note |
| Stop Light Switch | Stop light switch status/ ON or OFF |
| - |
| 1.INSPECT STOP LIGHT SWITCH |
![]() |
Remove the stop light switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Pin not pushed | Below 1 Ω |
| Pin pushed | 10 kΩ or higher | |
| 3 - 4 | Pin not pushed | 10 kΩ or higher |
| Pin pushed | Below 1 Ω |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (ECM - BATTERY) |
Disconnect the A24 ECM connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A24-36 (STP) - Body ground | Brake pedal is depressed | 11 to 14 V |
| A24-36 (STP) - Body ground | Brake pedal is released | Below 1 V |
|
| ||||
| OK | ||
| ||