FUEL INJECTOR > INSPECTION |
| 1. INSPECT FUEL INJECTOR ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 11.6 to 12.4 Ω |
Inspect the injection volume.
![]() |
Remove the fuel pipe clamp.
Disconnect the No. 1 fuel pipe sub-assembly (for quick type B) (Click here).
![]() |
Connect SST to the fuel pipe (the vehicle side).
![]() |
Install the O-ring to the fuel injector.
Install SST and a tube to the fuel injector.
![]() |
Pass SST (tie band) through the loop on the handle of SST (clamp) to secure SST (clamp) to SST (adapter).
Check that SST (clamp) and SST (adapter) cannot be easily separated.
Put the injector into a graduated cylinder.
Operate the fuel pump (turn the ignition switch to ON).
![]() |
Connect SST (wire) to the injector and the battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.
Check for leakage.
![]() |
In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leakage from the injector.