Home › ENGINE ยท 1UR-FE › FUEL › FUEL PUMP

FUEL PUMP > INSTALLATION

for Preparation Click here


HINT:
Perform "Inspection After Repairs" after replacing the fuel pump (Click here).



1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Apply a light coat of gasoline to a new gasket, and install it to the fuel tank.



    A152236E01
  1. Align the protrusion of the pump and gauge tube with the groove of the fuel tank.

  1. Install the fuel suction with pump and gauge tube into the fuel tank.

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

  1. Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer one complete turn by hand.



    A259584E01
  1. Set SST on the retainer.

    SST
    09808-14030  

    HINT:
    1. Hold the fuel suction tube assembly upright by hand to ensure that the fuel suction tube gasket is not moved out of position.
    2. Securely attach the claws of SST to the protrusions of the retainer and fix SST in place.
    3. Install SST while pressing the claws of SST against the retainer (toward the center of SST).



    A259587E01
  1. Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.

    SST
    09808-14030  

    HINT:
    Fit the tips of SST onto the ribs of the retainer.



    A152247
  1. Install the 2 fuel tank tubes with the 2 tube joint clips.

    NOTICE:
    A118171E02
    1. Check that there are no scratches or foreign objects on the connecting parts.
    2. Check that the fuel tube joints are inserted securely.
    3. Check that the tube joint clips are on the collars of the fuel tube joints.
    4. After installing the tube joint clips, check that the fuel tube joints have not been pulled off.



2. INSTALL FUEL TANK ASSEMBLY
  1. Install the fuel tank (Click here).