DTC P011B Engine Coolant Temperature / Intake Air Temperature Correlation |
| DTC Code | DTC Detection Condition | Trouble Area |
| P011B |
|
|

| Related DTCs | P011B: Engine Coolant Temperature (ECT) / Intake Air Temperature (IAT) sensor correlation |
| Required Sensors/Components (Main) | ECT / IAT sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | - |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| The monitor will run whenever these DTCs are not stored | P0102, P0103 (Mass air flow meter) P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0125 (Insufficient coolant temperature for closed loop fuel control) P2610 (ECM internal engine off timer) |
| All of following conditions met | - |
| 1. All of following conditions met | Conditions (a), (b), (c) and (d) |
| (a) Time engine not running after ignition switch ON | Less than 20 seconds |
| (b) Soak time | 7 hours or more |
| (c) Battery voltage | 10.5 V or higher |
| (d) Time after engine start | 15 seconds or more |
| Either of the following conditions are met | Condition (a) and (b) |
| (a) Minimum IAT after engine start | -10°C (14°F) or higher |
| (b) ECT before engine start | -10°C (14°F) or higher |
| Temperature deviation (difference between ECT and IAT) | More than 25°C (45°F) or less than -25°C (-45°F) |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P011B) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P011B output | A |
| P011B and other DTCs output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (INTAKE AIR TEMPERATURE) |
Leave the vehicle for 7 hours or more.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Intake Air.
Read the value displayed on the Techstream.
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (COOLANT TEMPERATURE) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / All Data / Coolant Temp.
Read the value displayed on the Techstream.
|
| ||||
| OK | ||
| ||