DTC B2602 Key Unlock Warning Switch Circuit Malfunction |
| DTC Code | Detection Condition | Trouble Area |
| B2602 | When both conditions below are met:
|
|

| 1.CHECK OTHER DTC OUTPUT |
Check if the power tilt and telescopic steering column system DTC B2621 is output.
| DTC Condition | Proceed to |
| B2621 is not output | A |
| B2621 is output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (KEY SWITCH COMMUNICATION SIGNAL) |
Use the Data List to check if the key communication signal is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key Switch(CAN) | Communication state of unlock warning switch signal / ON or OFF | ON: Communication is normal OFF: Communication is interrupted | - |
| Result | Proceed to |
| "OFF" is displayed. | A |
| "ON" is displayed. | B |
|
| ||||
| A | |
| 3.INSPECT UNLOCK WARNING SWITCH |

Disconnect the J18 connector from the unlock warning switch.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Unlock warning switch OFF (Ignition key is removed) | 10 kΩ or higher |
| 1 - 2 | Unlock warning switch ON (Ignition key is inserted) | Below 1 Ω |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - UNLOCK WARNING SWITCH) |

Disconnect the J1 main body ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J1-5 (KSW) - J18-1 | Always | Below 1 Ω |
| J1-5 (KSW) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J18-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | ||
| ||