Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > AVC-LAN Circuit

for Preparation Click here


DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transfers the switch signals using the AVC-LAN.
If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM


E280962E02


INSPECTION PROCEDURE

HINT:
The navigation receiver assembly is the master unit.

1.INSPECT NAVIGATION RECEIVER ASSEMBLY
E280968E02
  1. for Column Shift Type:

    1. Remove the navigation receiver assembly with the connector(s) still connected (Click here).

  1. for Floor Shift Type:

    1. Remove the navigation receiver assembly with the connector(s) still connected (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    7 (TX1+) - 8 (TX1-)
    Always
    60 to 80 Ω

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)
  1. Disconnect the J135 navigation receiver assembly connector.

  1. Disconnect the J141 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J141-8 (TX+) - J135-7 (TX1+)
    Always
    Below 1 Ω
    J141-7 (TX-) - J135-8 (TX1-)
    Always
    Below 1 Ω
    J141-8 (TX+) - Body ground
    Always
    10 kΩ or higher
    J141-7 (TX-) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT MALFUNCTIONING PARTS
  1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal operation.

    HINT:
    1. Check all slave units.
    2. If disconnecting a slave unit causes the master unit to return to normal operation, the slave unit is defective and should be replaced.

    OK:
    Master unit returns to normal operation.

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A

REPLACE MALFUNCTIONING PARTS