PARKING BRAKE PEDAL > INSTALLATION |
| 1. INSTALL PARKING BRAKE CONTROL PEDAL ASSEMBLY |
![]() |
Install the control pedal to the body with the 3 nuts.
![]() |
Attach the wire harness clamp to the control pedal.
Connect the parking brake switch connector.
| 2. CONNECT NO. 1 PARKING BRAKE CABLE ASSEMBLY |
![]() |
Connect the parking brake cable to the control pedal.
Using needle-nose pliers, slowly bend down the claw.
![]() |
Install the clip to the control pedal.
![]() |
Temporarily install the adjustment nut and lock nut.
| 3. CHECK PARKING BRAKE PEDAL TRAVEL |
Firmly depress the parking brake pedal.
Release the parking brake.
Slowly depress the parking brake pedal with a force of approximately 300 N (31 kgf, 67.4 lbf) and count the number of clicks.
| 4. ADJUST PARKING BRAKE PEDAL TRAVEL |
Depress the parking brake pedal.
![]() |
Apply load equivalent to 4 kN (408 kgf, 899.2 lbf) on equalizer twice to pull No. 2 and No. 3 parking brake cable to remove initial elongation.
Release the parking brake pedal to the original position.
![]() |
Loosen the pedal side No. 1 parking brake cable lock nut.
Turn the pedal side No. 1 parking brake cable adjustment nut until the parking brake pedal travel is correct.
| Pedal Load | Specified Condition |
| 300 N (31 kgf, 67.4 lbf) | 6 to 9 clicks |
Using a wrench or equivalent to hold the adjustment nut, tighten the lock nut.
Additionally, excessive pedal travel can be adjusted on the No. 1 parking brake cable underbody side as follows.
Release the parking brake pedal to the original position.
![]() |
Loosen the underbody side No. 1 parking brake cable lock nut.
Turn the underbody side No. 1 parking brake cable adjustment nut until the parking brake pedal travel is correct.
| Pedal Load | Specified Condition |
| 300 N (31 kgf, 67.4 lbf) | 6 to 9 clicks |
Tighten the No. 1 parking brake cable underbody lock nut.
Depress and release the parking brake pedal 3 or 4 times. Then check the number of clicks when depressing the pedal.
Check whether the parking brake drags or not.
If the parking brake drags, adjust the shoe clearance.
When operating the parking brake pedal, check that the parking brake pedal indicator light comes on at the first notch.
If not, adjust the parking brake switch installation position.
| 5. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |