CHARGING SYSTEM > Charging Failure |
| 1.CHECK GENERATOR WITH CLUTCH PULLEY (ON-VEHICLE INSPECTION) |
Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.
|
| ||||
| OK | |
| 2.CHECK GENERATOR WITH CLUTCH PULLEY (UNIT INSPECTION) |
Remove the generator assembly (Click here).
Check the installation condition of the generator pulley cap.
Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).
Check the generator with clutch pulley for misalignment (interference with the generator assembly).
![]() |
Turn the generator with clutch pulley clockwise and counterclockwise by hand and check for noise.
Turn the generator with clutch pulley clockwise and counterclockwise by hand and visually check for runout.
![]() |
Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator with clutch pulley locks when turned clockwise and turns freely when turned counterclockwise.
|
| ||||
| OK | ||
| ||