CHARGING SYSTEM > Noise Occurs from V-ribbed Belt or Generator Assembly |
| 1.CONFIRM PROBLEM SYMPTOM |
Confirm the problem symptom.
| Symptom | Proceed to |
| Noise occurs from fan and generator V belt | A |
| Noise occurs from generator assembly | B |
|
| ||||
| OK | |
| 2.CHECK FAN AND GENERATOR V BELT FOR WEAR |
Check the fan and generator V belt for wear or damage.
|
| ||||
| OK | |
| 3.CHECK GENERATOR PULLEY WITH CLUTCH FOR WEAR |
Check the generator with clutch pulley grooves for wear or damage.
|
| ||||
| OK | |
| 4.CHECK FOR NOISE WHILE CLUTCH PULLEY IS OPERATING |
Start the engine and check the generator with clutch pulley for looseness.
|
| ||||
| OK | |
| 5.INSPECT GENERATOR WITH CLUTCH PULLEY (UNIT INSPECTION) |
Remove the generator assembly (Click here).
Check the installation condition of the generator pulley cap.
Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).
Check the generator with clutch pulley for misalignment (interference with the generator assembly).
![]() |
Turn the generator with clutch pulley clockwise and counterclockwise by hand and check for noise.
Turn the generator with clutch pulley clockwise and counterclockwise by hand and visually check for runout.
![]() |
Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator with clutch pulley locks when turned clockwise and turns freely when turned counterclockwise.
|
| ||||
| OK | ||
| ||
| 6.CHECK FOR NOISE WHEN ROTOR IS TURNING FREELY |
Perform a road test and check that noise does not occur when decelerating.
Turn the engine off and check that no noise is produced by the generator with clutch pulley as the engine stops.
|
| ||||
| OK | |
| 7.CHECK ENGAGEMENT OF GENERATOR WITH CLUTCH PULLEY |
Remove the generator assembly (Click here).
![]() |
Using a screwdriver, hold the fan in the generator rotor assembly located inside the generator assembly in place and check that the generator with clutch pulley locks when turned clockwise (locking direction).
|
| ||||
| OK | ||
| ||