SHIFT LEVER ASSEMBLY (for Column Shift Type) > INSTALLATION |
| 1. INSTALL COLUMN SHIFT ASSEMBLY |
![]() |
Using a T30 ''TORX'' wrench, install the column shift with the 3 bolts.
Connect the connector and attach the harness clamp.
![]() |
Connect the column shift transmission control cable end to the column shift.
| 2. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY |
| 3. ADJUST SHIFT LEVER POSITION |
Move the shift lever to the N position.
![]() |
Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press the lock piece from the back side to release the lock.
![]() |
Check that the adjust case's spring is applying enough tension to the shift control cable. Then press the lock piece to set the lock.
Return the cover of the adjust case to its original position.
Inspect the operation after the adjustment.
| 4. INSPECT SHIFT LEVER POSITION |
When moving the shift lever from the N position to other positions, check that the lever can be shifted smoothly and accurately to each position and that the position indicator comes on in accordance with the shift lever position.
If the indicator and shift lever position do not match, carry out the following adjustment procedures.