Home › BRAKE › BRAKE › BRAKE PEDAL

BRAKE PEDAL > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



3. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY
  1. Remove the lower No. 1 instrument panel airbag assembly (Click here).



4. REMOVE NO. 1 AIR DUCT SUB-ASSEMBLY


    C154523
  1. Remove the bolt and air duct.



5. REMOVE PUSH ROD PIN
  1. Remove the clip and push rod pin from the brake pedal lever.



6. REMOVE STOP LIGHT SWITCH ASSEMBLY
  1. Disconnect the stop light switch connector.

  1. Remove the stop light switch .

  1. Detach the harness clip.



7. REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER
  1. Remove the stop light switch mounting adjuster .



8. REMOVE BRAKE PEDAL SUPPORT SUB-ASSEMBLY


    C208544E01
  1. Remove the brake pedal return spring.

  1. Remove the bolt from the No. 3 brake pedal bracket.



    C208543
  1. Remove the bolt, nut and No. 3 brake pedal bracket from the brake pedal support.



    C154462
  1. Remove the 4 nuts and brake pedal support.



9. REMOVE BRAKE PEDAL PAD
  1. Remove the brake pedal pad.