Home › DRIVE LINE › WF1AM TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > REMOVAL

for Preparation Click here


CAUTION:
Be sure to perform this procedure with several people as the transfer assembly is very heavy.

NOTICE:
Change the vehicle to 2WD mode before removing the transfer shift actuator assembly.
If the vehicle cannot be changed to 2WD mode, since the new transfer shift actuator assembly is set in the 2WD position, connect all the connectors to the vehicle side wire harnesses to set the new transfer shift actuator assembly to the drive state of the vehicle before installing the new transfer shift actuator assembly.



1. DRAIN TRANSFER OIL
  1. Remove the lower transfer case protector .



    C291184E01
  1. Remove the transfer case plug (filler) and transfer case plug (drain), and drain the transfer oil.
    Text in Illustration 
    *1
    Transfer Case Plug (Filler)
    *2
    Transfer Case Plug (Drain)



2. REMOVE FRONT PROPELLER SHAFT ASSEMBLY
(Click here)


3. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(Click here)


4. SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY
  1. for A760F:
  2. for AB60F:


5. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY


    C291197
  1. Remove the 4 bolts of the rear No. 1 engine mounting insulator.



    C291198
  1. Remove the 4 nuts, 4 washers, 4 bolts and No. 3 frame crossmember sub-assembly.



6. REMOVE REAR NO. 1 ENGINE MOUNTING INSULATOR


    C291199
  1. Remove the 4 bolts and rear No. 1 engine mounting insulator from the transfer assembly.



7. SUPPORT TRANSFER ASSEMBLY


    C291196
  1. Support the transfer assembly with a transmission jack.

    NOTICE:
    Secure the transfer assembly to the transmission jack using a belt, etc. to prevent it from falling.



8. DISCONNECT WIRE HARNESS AND CONNECTOR


    C291192E01
  1. Disconnect the 3 connectors, 4 clamps and transfer breather hose.
    Text in Illustration 
    *1
    Transfer Breather Hose



9. REMOVE TRANSFER ASSEMBLY
  1. Remove the 8 bolts.

  1. Pull the transfer assembly straight up and remove it from the automatic transmission assembly.

    NOTICE:
    Take care not to damage the rear adaptor oil seal with the transfer input shaft spline.