Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CAMSHAFT POSITION SENSOR

CAMSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 2 EMISSION CONTROL VALVE SET
(Click here)


2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A238086
  1. Disconnect the ventilation hose and vacuum hose.

  1. Detach the wire harness clamp.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose.



3. REMOVE VVT SENSOR (for Intake Side of Bank 1)


    A221424
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



4. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)


    A221425
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



5. REMOVE VVT SENSOR (for Intake Side of Bank 2)


    A221426
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.



6. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)


    A221427
  1. Disconnect the sensor connector.

  1. Remove the bolt and sensor.