Home › ENGINE ยท 1GR-FE › ENGINE CONTROL SYSTEM › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE GENERATOR ASSEMBLY
(Click here)


2. DISCONNECT COOLER COMPRESSOR ASSEMBLY
  1. Disconnect the cooler compressor connector.



    A238276
  1. Remove the 2 bolts, 2 nuts and 2 stud bolts and disconnect the cooler compressor.

    HINT:
    It is not necessary to completely remove the compressor. With the hoses connected to the compressor, hang the compressor on the vehicle body with a rope.



3. REMOVE CRANKSHAFT POSITION SENSOR


    A076417
  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt and crankshaft position sensor.