REAR CRANKSHAFT OIL SEAL > INSTALLATION |
| 1. INSTALL REAR CRANKSHAFT OIL SEAL |
![]() |
Apply MP grease to the lip of a new oil seal.
Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
| 2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
![]() |
Using SST, hold the crankshaft.
![]() |
Install the front spacer, drive plate and rear spacer to the crankshaft.
| *1 | Front Spacer |
| *2 | Drive Plate and Ring Gear |
| *3 | Rear Spacer |
![]() | Automatic Transmission Side |
Clean the bolts and bolt holes.
![]() |
Apply adhesive to 2 or 3 threads at the end of each of the 8 bolts.
| *1 | Adhesive |
![]() |
Install and uniformly tighten the 8 bolts in several steps in the sequence shown in the illustration.
| 3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY |