Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Rear Clearance Sonar Sensor RH Circuit

for Preparation Click here


DESCRIPTION

The No. 2 ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.

WIRING DIAGRAM


E270572E04


INSPECTION PROCEDURE

1.INSPECT NO. 2 ULTRASONIC SENSOR (REAR CORNER SENSOR RH)
  1. Remove the No. 2 ultrasonic sensor (rear corner sensor RH) (Click here).

  1. Inspect the No. 2 ultrasonic sensor (rear corner sensor RH) (Click here).



NG
REPLACE NO. 2 ULTRASONIC SENSOR (REAR CORNER SENSOR RH) (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (REAR CORNER SENSOR RH - CLEARANCE WARNING ECU ASSEMBLY)
  1. Disconnect the S4 No. 2 ultrasonic sensor (rear corner sensor RH) connector.

  1. Disconnect the J35 clearance warning ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    S4-1 (BI) - J35-12 (BOR)
    Always
    Below 1 Ω
    S4-3 (SI) - J35-14 (SOR)
    Always
    Below 1 Ω
    S4-5 (EI) - J35-13 (E1)
    Always
    Below 1 Ω
    S4-1 (BI) - Body ground
    Always
    10 kΩ or higher
    S4-3 (SI) - Body ground
    Always
    10 kΩ or higher
    S4-5 (EI) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)