INTUITIVE PARKING ASSIST SYSTEM > Back Sonar Sensor LH Circuit |

| 1.INSPECT NO. 3 ULTRASONIC SENSOR (REAR CENTER SENSOR LH) |
Remove the No. 3 ultrasonic sensor (rear center sensor LH) (Click here).
Inspect the No. 3 ultrasonic sensor (rear center sensor LH) (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (REAR CENTER SENSOR LH - REAR CENTER SENSOR RH) |
Disconnect the S2 No. 3 ultrasonic sensor (rear center sensor LH) connector.
Disconnect the S3 No. 3 ultrasonic sensor (rear center sensor RH) connector.
Measure the Resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| S2-1 (BI) - S3-2 (BO) | Always | Below 1 Ω |
| S2-3 (SI) - S3-4 (SO) | Always | Below 1 Ω |
| S2-5 (EI) - S3-6 (EO) | Always | Below 1 Ω |
| S2-1 (BI) - Body ground | Always | 10 kΩ or higher |
| S2-3 (SI) - Body ground | Always | 10 kΩ or higher |
| S2-5 (EI) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||