Home › BODY ELECTRICAL › AUDIO / VISUAL › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Microphone Circuit between Microphone and Radio Receiver

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the radio and display receiver assembly.
It also supplies power from the radio and display receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E280091E07


INSPECTION PROCEDURE

1.CHECK RADIO AND DISPLAY RECEIVER ASSEMBLY


    E280108E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J139-19 (MIN-) - Body ground
    Always
    Below 1 Ω
    J139-18 (SGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J139-4 (MACC) - Body ground
    Ignition switch ACC
    4.75 to 5.25 V

    Text in Illustration 
    *a
    Component with harness connected
    (Radio and Display Receiver Assembly)
    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)

C
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - ROOF CONSOLE BOX)
  1. Disconnect the J139 radio and display receiver assembly connector.

  1. Disconnect the W7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J139-4 (MACC) - W7-10 (ACC)
    Always
    Below 1 Ω
    J139-5 (MIN+) - W7-9 (MI1+)
    Always
    Below 1 Ω
    J139-19 (MIN-) - W7-8 (MIC-)
    Always
    Below 1 Ω
    J139-6 (SNS2) - W7-14 (SGND)
    Always
    Below 1 Ω
    J139-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    J139-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    J139-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    J139-18 (SGND) - Body ground
    Always
    10 kΩ or higher
    J139-6 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE TELEPHONE MICROPHONE WITH ANOTHER AND CHECK
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE IS DEFECTIVE)