Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Microphone Circuit between Microphone and Navigation Receiver Assembly

for Preparation Click here


DESCRIPTION

This circuit sends a microphone signal from the telephone microphone assembly to the navigation receiver assembly.
It also supplies power from the navigation receiver assembly to the telephone microphone assembly.

WIRING DIAGRAM


E280091E14


INSPECTION PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY


    E280108E04
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J135-19 (MIN-) - Body ground
    Always
    Below 1 Ω
    J135-18 (SGND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J135-4 (MACC) - Body ground
    Ignition switch ACC
    4.75 to 5.25 V

    Text in Illustration 
    *a
    Component with harness connected
    (Navigation Receiver Assembly)
    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A


2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - ROOF CONSOLE BOX ASSEMBLY)
  1. Disconnect the J135 navigation receiver assembly connector.

  1. Disconnect the W7 roof console box assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J135-4 (MACC) - W7-10 (ACC)
    Always
    Below 1 Ω
    J135-5 (MIN+) - W7-9 (MI1+)
    Always
    Below 1 Ω
    J135-19 (MIN-) - W7-8 (MIC-)
    Always
    Below 1 Ω
    J135-6 (SNS2) - W7-14 (SGND)
    Always
    Below 1 Ω
    J135-4 (MACC) - Body ground
    Always
    10 kΩ or higher
    J135-5 (MIN+) - Body ground
    Always
    10 kΩ or higher
    J135-19 (MIN-) - Body ground
    Always
    10 kΩ or higher
    J135-18 (SGND) - Body ground
    Always
    10 kΩ or higher
    J135-6 (SNS2) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK TELEPHONE MICROPHONE ASSEMBLY
  1. Replace the telephone microphone assembly with a known good one (Click here).

  1. Check if the same problem occurs again.

    OK:
    Malfunction disappears.



NG
REPLACE ROOF CONSOLE BOX ASSEMBLY (Click here)
OK

END (TELEPHONE MICROPHONE ASSEMBLY IS DEFECTIVE)