EXHAUST PIPE > INSTALLATION |
| 1. INSTALL AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1) |
![]() |
Install the air fuel ratio sensor to the exhaust pipe assembly by hand.
![]() |
Using SST, tighten the air fuel ratio sensor sensor.
| *a | Fulcrum length |
| 2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2) |
![]() |
Install the heated oxygen sensor to the front exhaust pipe assembly by hand.
![]() |
Using SST, tighten the heated oxygen sensor.
| *a | Fulcrum length |
| 3. INSTALL FRONT EXHAUST PIPE ASSEMBLY |
Install a new gasket and the front exhaust pipe assembly to the exhaust manifold sub-assembly RH with 3 new nuts.
| 4. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1) |
![]() |
Install the air fuel ratio sensor to the front No. 2 exhaust pipe assembly by hand.
![]() |
Using SST, tighten the air fuel ratio sensor.
| *a | Fulcrum length |
| 5. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2) |
![]() |
Install the heated oxygen sensor to the front No. 2 exhaust pipe assembly by hand.
![]() |
Using SST, tighten the heated oxygen sensor.
| *a | Fulcrum length |
| 6. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY |
Connect the front No. 2 exhaust pipe assembly to the exhaust pipe support.
Install a new gasket and the front No. 2 exhaust pipe assembly to the exhaust manifold sub-assembly LH with 3 new nuts.
| 7. INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) |
| 8. INSTALL CENTER EXHAUST PIPE ASSEMBLY |
Connect the center exhaust pipe assembly to the 3 exhaust pipe supports.
Install 2 new gaskets to the front exhaust pipe assembly and front No. 2 exhaust pipe assembly.
Install the center exhaust pipe assembly with the 4 bolts.
| 9. INSTALL TAILPIPE ASSEMBLY |
Connect the tailpipe assembly to the exhaust pipe support.
Install a new gasket to the center exhaust pipe assembly.
![]() |
Attach a new clamp to the tailpipe assembly and center exhaust pipe assembly. Then install the bolt to the clamp.
| *a | Top |
| *b | LH Side of Vehicle |
| *c | Front Side of Vehicle |
| 10. INSPECT FOR EXHAUST GAS LEAK |