Home › ENGINE ยท 1UR-FE › EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe assembly.
  2. The exhaust pipe assembly is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe assembly has cooled down before removing it.



1. REMOVE HEATED OXYGEN SENSOR
(Click here)


2. REMOVE TAILPIPE ASSEMBLY
  1. Remove the bolt and clamp.

  1. Disconnect the exhaust pipe support to remove the tailpipe assembly.

  1. Remove the gasket.



3. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 4 bolts.

  1. Disconnect the 3 exhaust pipe supports to remove the center exhaust pipe assembly.

  1. Remove the 2 gaskets.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Remove the 3 nuts and front exhaust pipe assembly.

  1. Remove the gasket.



5. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A215441E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



6. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Remove the 3 nuts.

  1. Disconnect the exhaust pipe support to remove the front No. 2 exhaust pipe assembly.

  1. Remove the gasket.



7. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
  1. Disconnect the air fuel ratio sensor connector.



    A215438E01
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010