Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > REMOVAL

for Preparation Click here


NOTICE:
  1. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU after the ECU has been replaced.
  2. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the intelligent tester or Techstream and write them down before removal.



1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH
(Click here)


2. REMOVE CLEARANCE WARNING ECU WITH BRACKET


    B354801
  1. Disconnect the ECU connectors and detach the harness clamp.

    NOTICE:
    Do not apply excessive force to the wire harnesses.

  1. Remove the bolt, nut and clearance warning ECU with bracket.



3. REMOVE TIRE PRESSURE WARNING ECU


    C295013
  1. Remove the 2 nuts and tire pressure warning ECU.

    NOTICE:
    1. Avoid any impact to the tire pressure warning ECU.
    2. Do not drop the tire pressure warning ECU. If it is dropped, replace it with a new one.