Home › ENGINE ยท 1UR-FE › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > REMOVAL

for Preparation Click here



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


3. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH
(Click here)


4. REMOVE STARTER COVER


    A215551
  1. Remove the 3 bolts and starter cover.



5. REMOVE STARTER ASSEMBLY


    A258285
  1. Detach the 2 wire harness clamps.

  1. Disconnect the starter connector.

  1. Remove the nut and disconnect the starter wire.



    A258286
  1. Remove the 2 bolts and starter.



    A215546
  1. Remove the flywheel housing side cover.