EXHAUST MANIFOLD > REMOVAL |
| 1. REMOVE FRONT FENDER APRON SEAL RH |
Remove the 6 clips and fender apron seal.
| 2. REMOVE FRONT FENDER APRON SEAL REAR RH |
Remove the 5 clips and fender apron seal.
| 3. REMOVE FRONT FENDER APRON SEAL LH |
Remove the 6 clips and fender apron seal.
| 4. REMOVE FRONT FENDER APRON SEAL REAR LH |
Remove the 5 clips and fender apron seal.
| 5. REMOVE INTAKE MANIFOLD |
| 6. REMOVE GENERATOR ASSEMBLY |
| 7. DISCONNECT COOLER COMPRESSOR ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 bolts and 2 nuts.
Remove the 2 stud bolts and cooler compressor assembly.
| 8. REMOVE ENGINE OIL LEVEL DIPSTICK GUIDE |
Remove the dipstick.
![]() |
Remove the bolt and dipstick guide.
Remove the O-ring from dipstick guide.
| 9. REMOVE EXHAUST PIPE ASSEMBLY |
| 10. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (for 4WD) |
| 11. REMOVE FRONT NO. 4 FLOOR HEAT INSULATOR |
![]() |
Remove the 4 nuts and front floor heat insulator.
| 12. REMOVE FRONT NO. 3 FLOOR HEAT INSULATOR |
![]() |
Remove the 4 nuts and front floor heat insulator.
| 13. REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY |
![]() |
Remove the 4 nuts and EGR pipe.
Remove the 2 gaskets.
| 14. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and heat insulator.
| 15. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH |
![]() |
Remove the 9 nuts, exhaust manifold and 2 gaskets.
| 16. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR |
![]() |
Remove the 3 bolts and heat insulator.
| 17. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH |
![]() |
Remove the 9 nuts, exhaust manifold and 2 gaskets.