IGNITION SYSTEM > ON-VEHICLE INSPECTION |
| 1. PERFORM SPARK TEST |
Check for DTCs (Click here).
Check if sparks occur.
Remove the ignition coils and spark plugs (Click here).
Install the spark plug to the ignition coil and connect the ignition coil connector.
Disconnect the 8 injector connectors.
![]() |
Ground the spark plug.
Visually check that sparks occur while the engine is being cranked.
| 2. INSPECT IGNITION COIL AND SPARK PLUG |
Spark test flowchart.
Check that the wire harness side connector of the ignition coil with igniter is securely connected.
| Result | Proceed to |
| NG | Connect securely |
| OK | Go to next step |
Perform a spark test on each ignition coil with igniter.
| Result | Proceed to |
| OK | Replace ignition coil with igniter |
| NG | Go to next step |
Check the power supply to the ignition coil with igniter.
| Result | Proceed to |
| NG | Check wiring between ignition switch and ignition coil with igniter |
| OK | Go to next step |
Check spark plug.
| Result | Proceed to |
| NG | Replace spark plug |
| OK | Inspect the ignition system (Click here) |
Connect the 8 injector connectors.
Install the ignition coils and spark plugs (Click here).
| 3. INSPECT SPARK PLUG |
Check the electrode.
![]() |
Using a megohmmeter, measure the insulation resistance.
| Tester Connection | Condition | Specified Condition |
| Spark plug (terminal part) - Body ground | Always | 10 MΩ or higher |
Alternative inspection method:*
Start the engine.*
Quickly accelerate the engine to 4000 rpm 5 times.*
Remove the spark plug.
![]() |
Visually check the spark plug.
If the electrode is dry, the spark plug is functioning properly. If the electrode is damp, proceed to the next step.
Check the spark plug for any damage to its threads and insulator.
If there is any damage, replace the spark plug.
| Manufacturer | Type |
| DENSO made | SK20HR11 |
![]() ![]() |
Check the spark plug electrode gap.