Home › ENGINE ยท 1UR-FE › ENGINE CONTROL SYSTEM › KNOCK SENSOR

KNOCK SENSOR > REMOVAL

for Preparation Click here



1. REMOVE INTAKE MANIFOLD
(Click here)


2. DISCONNECT NO. 10 WATER BY-PASS HOSE


    A313309
  1. Slide the clamp and remove the No. 10 water by-pass hose from the separator case.



3. DISCONNECT NO. 9 WATER BY-PASS HOSE


    A313310
  1. Slide the clamp and remove the No. 9 water by-pass hose from the separator case.



4. REMOVE SEPARATOR CASE


    A272394
  1. Remove the 4 bolts and separator case.



5. REMOVE KNOCK SENSOR


    A215436
  1. Disconnect the 4 knock sensor connectors.

  1. Remove the 4 bolts and 4 knock sensors.