Home › ENGINE ยท 3UR-FBE › ENGINE MECHANICAL › CYLINDER HEAD GASKET (for Bank 1)

CYLINDER HEAD GASKET (for Bank 1) > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY LH
  1. Remove the exhaust manifold LH (Click here).



2. REMOVE CAMSHAFTS (for Bank 1)
  1. Remove the camshafts (Click here).



3. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
  1. Remove the 16 valve rocker arms from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



4. REMOVE VALVE LASH ADJUSTER ASSEMBLY
  1. Remove the 16 valve lash adjusters from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



5. REMOVE VALVE STEM CAP
  1. Remove the 16 valve stem caps from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



6. REMOVE CYLINDER HEAD SUB-ASSEMBLY LH


    A160736E02
  1. Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.



    A160737E02
  1. Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.

    HINT:
    Be sure to arrange the removed parts for each installation position separately.

    NOTICE:
    1. Be careful not to drop washers into the cylinder head.
    2. Head warpage or cracking could result from removing bolts in an incorrect order.



7. REMOVE CYLINDER HEAD GASKET LH