DTC B1273 Sliding Roof ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B1273 | No communication between sliding roof drive gear sub-assembly and main body ECU (driver side junction block) for 10 seconds or more |
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1273 output reoccurs | A |
| DTC B1273 output does not reoccur | B |
|
| ||||
| A | |
| 3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - SLIDING ROOF DRIVE GEAR) |

Disconnect the J2 main body ECU (driver side junction block) connector.
Disconnect the W3 sliding roof drive gear sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J2-10 (LIN2) - W3-3 (LIN) | Always | Below 1 Ω |
| J2-10 (LIN2) or W3-3 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (SLIDING ROOF DRIVE GEAR - BATTERY AND BODY GROUND) |
![]() |
Disconnect the W3 sliding roof drive gear sub-assembly connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| W3-8 (E) - Body ground | Always | Below 1 Ω |
| Tester Connection | Switch Condition | Specified Condition |
| W3-9 (IG) - Body ground | Ignition switch ON | 11 to 14 V |
| W3-10 (B) - Body ground | Always | 11 to 14 V |
|
| ||||
| OK | |
| 5.REPLACE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
Temporarily replace the sliding roof drive gear sub-assembly with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 6.CHECK FOR DTC |
Check for DTCs (Click here).
| Result | Proceed to |
| DTC B1273 output does not reoccur | A |
| DTC B1273 output reoccurs | B |
|
| ||||
| A | ||
| ||