Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

DTC    B1206    P/W Master Switch Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is output when LIN communication between the power window regulator master switch assembly and main body ECU (driver side junction block) stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B1206
No communication between the power window regulator master switch assembly and main body ECU (driver side junction block) for 10 seconds or more.
  1. Power window regulator master switch assembly
  2. Main body ECU (driver side junction block)
  3. Harness or connector

WIRING DIAGRAM


E164259E04


INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.

HINT:
DTC B2325 is stored when communication between the master switch and main body ECU (driver side junction block) stops.

1.CLEAR DTC
  1. Clear the DTC (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1206 output reoccurs
    A
    DTC B1206 output does not reoccur
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A


3.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - MASTER SWITCH)


    E160666E02
  1. Disconnect the J2 main body ECU (driver side junction block) connector.

  1. Disconnect the N2 power window regulator master switch assembly connector.

  1. Measure the resistance according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J2-10 (LIN2) - N2-6 (LIN1)
    Always
    Below 1 Ω
    J2-10 (LIN2) or N2-6 (LIN1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY (MASTER SWITCH - BATTERY AND BODY GROUND)


    E160667E04
  1. Disconnect the N2 power window regulator master switch assembly connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    N2-1 (E) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    N2-3 (B) - Body ground
    Always
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


5.REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
  1. Temporarily replace the power window regulator master switch assembly with a new or normally functioning one (Click here).

  1. Clear the DTC (Click here).


NEXT


6.CHECK FOR DTC
  1. Check for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B1206 output does not reoccur
    A
    DTC B1206 output reoccurs
    B



B
REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)
A

END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY IS DEFECTIVE)