Home › COMMUNICATION SYSTEM › MULTIPLEX COMMUNICATION › LIN COMMUNICATION SYSTEM

LIN COMMUNICATION SYSTEM > Integration Control and Panel Assembly Communication Error

for Preparation Click here


DESCRIPTION

The LIN communication of the components related to the mirror heater occurs between the air conditioning amplifier assembly and air conditioning control assembly.

WIRING DIAGRAM


B166129E02


INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch OFF to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the tester and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER ASSEMBLY - AIR CONDITIONING CONTROL ASSEMBLY)

B353582E01

  1. Disconnect the J127 air conditioning control assembly connector.

  1. Disconnect the J19 air conditioning amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J19-37 (LIN1) - J127-7 (STX)
    Always
    Below 1 Ω
    J19-37 (LIN1) or J127-7 (STX) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (AIR CONDITIONING CONTROL ASSEMBLY - BATTERY AND BODY GROUND)


    B353583E01
  1. Disconnect the J127 air conditioning control assembly connector.

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    J127-5 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J127-4 (IG+) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK AIR CONDITIONING CONTROL ASSEMBLY (OPERATION)
  1. Temporarily replace the air conditioning control assembly with a new or normally functioning one (Click here).

  1. Check that the malfunction disappears.

    OK:
    Malfunction disappears.



NG
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY (Click here)
OK

END (AIR CONDITIONING CONTROL ASSEMBLY IS DEFECTIVE)