Home › BODY ELECTRICAL › DOOR LOCK › POWER DOOR LOCK CONTROL SYSTEM

POWER DOOR LOCK CONTROL SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedures to troubleshoot the power door lock control system.
  1. *: Use the Techstream.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.INSPECT BATTERY VOLTAGE

      Standard voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

    NEXT


    3.PROBLEM SYMPTOMS TABLE
      Result 
      Result
      Proceed to
      Fault is not listed in problem symptoms table
      A
      Fault is listed in problem symptoms table
      B


    B.
    Go to step 5
    A


    4.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Operation Check (Click here)

    2. Terminals of ECU (Click here)

    3. DATA LIST/ACTIVE TEST (Click here)


    NEXT


    5.REPAIR OR REPLACE

      NEXT


      6.CONFIRMATION TEST

        NEXT

        END