Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL HEADLIGHT ASSEMBLY LH


E281329E01
  1. Put protective tape around the headlight assembly LH.
    Text in Illustration 
    *1
    Protective Tape

  1. Connect each connector and attach the clamp.

  1. Attach the claw to install the headlight assembly LH.

  1. Install the 2 screws and bolt.



2. INSTALL FRONT END PANEL LH
  1. Attach the 3 claws to install the front end panel LH.

  1. Install the 2 screws and 2 clips.



3. INSTALL RADIATOR GRILLE SUB-ASSEMBLY
  1. Attach the 4 claws and 3 clips to install the radiator grille sub-assembly.

  1. Install the 4 screws and 2 clips.

    Torque:
    3.0 N*m{ 31 kgf*cm , 27 in.*lbf }



4. ADJUST HEADLIGHT AIMING
(Click here)