Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

DTC    B1244    Light Sensor Circuit Malfunction

for Preparation Click here


DESCRIPTION

This DTC is output when a failure of the automatic light control sensor circuit is detected.

DTC Code
DTC Detection Condition
Trouble Area
B1244
When either condition below is met:
  1. Malfunction of light sensor
  2. Open or short of light sensor circuit
  1. Automatic light control sensor
  2. Harness or connector
  3. Main body ECU

WIRING DIAGRAM


E132905E10


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Recheck for DTC (Click here).

    OK:
    DTC B1244 is not output.



NG
Go to step 2
OK

USE SIMULATION METHOD TO CHECK (Click here)  

2.READ VALUE USING TECHSTREAM (AUTOMATIC LIGHT CONTROL SENSOR)
  1. Operate the Techstream according to the display and select "Data List".

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Illumination Rate Info
    Illumination rate / min.: 0, max.: 99.99
    Actual illumination rate is displayed
    -

    OK:
    Output illuminance is as shown in table above.



NG
Go to step 3
OK

REPLACE MAIN BODY ECU 

3.CHECK MAIN BODY ECU (LIGHT CONTROL SENSOR VOLTAGE)
E137455E03
  1. Disconnect the ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    20 (CLTB) - 18 (CLTE)
    Ignition switch ON
    11 to 14 V
    Ignition switch OFF
    Below 1 V



NG
REPLACE MAIN BODY ECU
OK


4.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - AUTOMATIC LIGHT CONTROL SENSOR)
E140027E08
  1. Disconnect the J3 ECU connector.

  1. Disconnect the J128 sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J3-20 (CLTB) - J128-6 (CLTB)
    Always
    Below 1 Ω
    J3-19 (CLTS) - J128-5 (CLTS)
    J3-18 (CLTE) - J128-3 (CLTE)
    J3-20 (CLTB) - Body ground
    Always
    10 kΩ or higher
    J3-19 (CLTS) - Body ground
    J3-18 (CLTE) - Body ground



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE AUTOMATIC LIGHT CONTROL SENSOR (Click here)