ENGINE IMMOBILISER SYSTEM > Security Indicator Light Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR LIGHT) |
Select the Active Test and use the Techstream to generate a command.
Check that the security indicator light operation is normal.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Security Indicator | Security indicator light | ON/OFF | - |
|
| ||||
| OK | |
| 2.CHECK TRANSPONDER KEY ECU |
![]() |
Remove the transponder key ECU with the connector still connected (Click here).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-8 (IND) - Body ground | Engine immobiliser system is set | Alternating between 11 to 14 V and below 1 V |
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (SECURITY INDICATOR LIGHT - TRANSPONDER KEY ECU) |
Disconnect the J28 combination meter connector.

Disconnect the J26 transponder key ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J28-37 (LP) - J26-8 (IND) | Always | Below 1 Ω |
| J28-37 (LP) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE COMBINATION METER ASSEMBLY |
Temporarily replace the combination meter assembly with a new or normally functioning one (Click here).
Check security indicator light.
|
| ||||
| OK | ||
| ||