Home › BODY › SEAT › FRONT SEATBACK HEATER (for Manual Seat)

FRONT SEATBACK HEATER (for Manual Seat) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.



1. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
Use the same procedure as for the driver seat (Click here).



2. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH
  1. Raise the reclining adjuster release handle RH to reveal the claw.



    B356049E01
  1. Using a screwdriver, detach the claw and remove the reclining adjuster release handle RH.

    HINT:
    Tape the screwdriver tip before use.

    Text in Illustration 
    *1
    Protective Tape



3. REMOVE FRONT SEAT CUSHION SHIELD RH


    B356050
  1. Disconnect the 2 rubber bands.



    B356051E01
  1. Remove the 3 screws.

  1. Detach the guide, clip and 2 claws as indicated by the arrows in the order shown in the illustration to remove the front seat cushion shield RH.



4. REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD RH


    B356052
  1. Remove the 2 screws.

  1. Detach the guide in the direction indicated by the arrow shown in the illustration to remove the front inner No. 1 seat cushion shield RH.



5. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY


    B354558
  1. Disconnect the connector.

  1. Detach the wire harness clamp to disconnect the wire harness of the front seatback heater assembly RH.



    B356053E01
  1. Detach the connector clamp and 3 wire harness clamps to disconnect the wire harness of the front seat airbag assembly RH.
    Text in Illustration 
    *1
    Connector Clamp
    *2
    Wire Harness Clamp



    B356054
  1. Remove the 4 bolts and separate type front seatback assembly.



6. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B356055
  1. Detach the hook.



    B356056
  1. Pull out the 2 wire harnesses from the separate type front seatback cover.



    B356057
  1. Open the 2 fasteners.



    B356058
  1. Detach the 2 hooks.

    1. Remove the 4 clips.

    2. Slide each hook to detach them.

  1. Pull out the 4 straps of the separate type front seatback cover from the separate type front seatback pad.



    B356059E01
  1. Detach the 6 fasteners.
    Text in Illustration 
    *1
    Fastener



    B354565
  1. Remove the 2 hog rings.



    B354567
  1. Detach the 4 claws to remove the 2 front seat headrest supports.

  1. Remove the separate type front seatback cover from the separate type front seatback pad.



7. REMOVE FRONT SEATBACK HEATER ASSEMBLY RH


    B356060
  1. Remove the 8 tack pins to remove the front seatback heater assembly RH.