Home › BODY › SEAT › POWER SEAT SWITCH (w/o Seat Position Memory System)

POWER SEAT SWITCH (w/o Seat Position Memory System) > REMOVAL

for Preparation Click here


CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.



1. REMOVE FRONT SEAT ASSEMBLY LH
(Click here)


2. REMOVE FRONT SEAT CUSHION SHIELD LH


    B354887
  1. Disconnect the 2 rubber bands.



    B354888E01
  1. Remove the 2 screws.

  1. Detach the guide, clip and 2 claws as indicated by the arrows in the order shown in the illustration.



    B354890E01
  1. w/o Leg Support Adjustment Switch:

    1. Detach the clamp and disconnect the 2 connectors to remove the front seat cushion shield LH.

  1. w/ Leg Support Adjustment Switch:

    1. Detach the clamp and disconnect the 4 connectors to remove the front seat cushion shield LH.
      Text in Illustration 
      *A
      w/o Leg Support Adjustment Switch
      *B
      w/ Leg Support Adjustment Switch



3. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB


    B354892
  1. Using moulding remover A, detach the 2 claws to remove the slide and vertical power seat switch knob.



4. REMOVE RECLINING POWER SEAT SWITCH KNOB


    B354893
  1. Using moulding remover A, detach the 2 claws to remove the reclining power seat switch knob.



5. REMOVE FRONT POWER SEAT SWITCH LH


    B356222
  1. Remove the 3 screws and front power seat switch LH.