Home › RESTRAINTS › SUPPLEMENTAL RESTRAINT SYSTEM › FRONT SEAT SIDE AIRBAG ASSEMBLY (for Power Seat)

FRONT SEAT SIDE AIRBAG ASSEMBLY (for Power Seat) > REMOVAL

for Preparation Click here


CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. If the side airbag was deployed, replace the front seat airbag assembly LH, front seat back cover and front seat frame with adjuster assembly with the necessary parts in accordance with the extent of the collision damage.
  3. Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.

HINT:
Use the same procedures for the LH side and RH side.



1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE FRONT SEAT ASSEMBLY LH
(Click here)


4. REMOVE FRONT SEAT CUSHION SHIELD LH


    B354887
  1. Disconnect the 2 rubber bands.



    B354888E01
  1. Remove the 2 screws.

  1. Detach the guide, clip and 2 claws as indicated by the arrows in the order shown in the illustration.



    B354890E01
  1. w/o Leg Support Adjustment Switch:

    1. Detach the clamp and disconnect the 2 connectors to remove the front seat cushion shield LH.

  1. w/ Leg Support Adjustment Switch:

    1. Detach the clamp and disconnect the 4 connectors to remove the front seat cushion shield LH.
      Text in Illustration 
      *A
      w/o Leg Support Adjustment Switch
      *B
      w/ Leg Support Adjustment Switch



5. REMOVE FRONT INNER NO. 1 SEAT CUSHION SHIELD LH


    B354898
  1. Remove the 2 screws.

  1. Detach the guide in the direction indicated by the arrow shown in the illustration to remove the front inner No. 1 seat cushion shield LH.



6. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY


    B354900
  1. w/ Seat Heater System:

    1. Disconnect the connector.

    2. Detach the wire harness clamp to disconnect the wire harness of the front seatback heater assembly LH.



    B354901
  1. Disconnect the connector.

  1. Detach the wire harness clamp to disconnect the wire harness of the front seatback wire LH.



    B354902E01
  1. Detach the connector clamp and 3 wire harness clamps to disconnect the wire harness of the front seat airbag assembly LH.
    Text in Illustration 
    *1
    Connector Clamp
    *2
    Wire Harness Clamp



    B354903
  1. Remove the 4 bolts and separate type front seatback assembly.



7. REMOVE SEPARATE TYPE FRONT SEATBACK COVER


    B354904
  1. Detach the hook.



    B354905E01
  1. w/o Seat Heater System:

    1. Pull out the 2 wire harnesses from the separate type front seatback cover.

  1. w/ Seat Heater System:

    1. Pull out the 3 wire harnesses from the separate type front seatback cover.
      Text in Illustration 
      *A
      w/ Seat Heater System



    B354906
  1. Open the 2 fasteners.



    B354907
  1. Detach the 2 hooks.

    1. Remove the 4 clips.

    2. Slide each hook to detach them.

  1. Pull out the 4 straps of the separate type front seatback cover from the separate type front seatback pad.



    B354911E01
  1. Detach the 6 fasteners.
    Text in Illustration 
    *1
    Fastener



    B354908
  1. Remove the 2 hog rings.



    B354910
  1. Detach the 4 claws to remove the 2 front seat headrest supports.

  1. Remove the separate type front seatback cover from the separate type front seatback pad.



8. REMOVE FRONT SEAT BACK HEATER ASSEMBLY LH (w/ Seat Heater System)


    B354912
  1. Remove the 8 tack pins to remove the front seatback heater assembly LH.



9. REMOVE SEPARATE TYPE FRONT SEATBACK PAD


    B354913
  1. w/ Climate Control Seat System:

    1. Detach the 6 clips.

  1. Remove the separate type front seatback pad from the front seatback frame sub-assembly LH.



10. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH


    B355990
  1. Detach the 2 clamps from the front seatback main frame sub-assembly.

  1. Remove the 2 nuts and front seat airbag assembly LH.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the front seat back main frame sub-assembly is not deformed. If it is, replace it with a new one.