Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

DTC    U0100    Lost Communication with ECM / PCM "A"

for Preparation Click here


DESCRIPTION

The combination meter communicates with the ECM via the CAN line.

DTC Code
DTC Detection Condition
Trouble Area
U0100
When either of following conditions is detected:
  1. Vehicle speed 5 km/h (3 mph) or more and IG voltage 10.5 V or more
  2. No communication with ECM continues for 3 seconds or more (No communication to ECM or skid control ECU continues for 60 seconds or more)
CAN communication system

WIRING DIAGRAM


E140490E55


INSPECTION PROCEDURE

1.CHECK FOR DTC
  1. Check for DTCs and note any codes that are output (Click here).

  1. Clear the DTC (Click here).

  1. Recheck for DTC (Click here).
    Result 
    Result
    Proceed to
    DTC U0100 is not output
    A
    DTC U0100 is output
    B

    HINT:
    If the CAN communication system DTC U0100 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0100 first.



B
Go to CAN COMMUNICATION SYSTEM (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)