Home › TRANSMISSION ยท A750E AUTOMATIC TRANSMISSION › SHIFT LEVER ASSEMBLY (for Floor Shift Type)

SHIFT LEVER ASSEMBLY (for Floor Shift Type) > INSTALLATION

for Preparation Click here



1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY


    C290569E01
  1. Temporarily install the transmission floor shift assembly to the body with the 4 bolts.

  1. Fully tighten the 4 bolts in the order shown in the illustration.

    Torque:
    14 N*m{ 143 kgf*cm , 10 ft.*lbf }

  1. Connect the clamp and 2 connectors.



    C179207
  1. Install the cable outer of the transmission control cable assembly to the shift lever retainer, and then install a new clip.



    C179205E02
  1. Connect the control cable end to the shift lever assembly.
    Text in Illustration 
    *1
    Ridged

    NOTICE:
    Make sure to install the cable end so that the inner cable is not twisted. Confirm that the cable ridged side of the cable end is facing upward.



2. ADJUST SHIFT LEVER POSITION
  1. Move the shift lever to N.



    C155901E03
  1. Fold back the transmission control cable adjust case cover. Then while sliding the slider toward the cable end side, press the lock piece from the back side to release the lock.
    Text in Illustration 
    *1
    Lock Piece
    *2
    Slider



    C155902E03
  1. Check that the spring of the adjust case is applying enough tension to the shift control cable. Then press the lock piece to set the lock.
    Text in Illustration 
    *1
    Lock Piece
    *2
    Slider

    NOTICE:
    1. Use your hand to push the lock piece. Do not use any tools.
    2. Securely push the lock piece so that the protrusion of the slider is above the lock piece.

  1. Return the cover of the adjust case to its original position.

  1. Inspect the operation after the adjustment.



3. INSPECT SHIFT LEVER POSITION
  1. When moving the shift lever from P to R with the ignition switch ON and brake pedal depressed, make sure that it moves smoothly and correctly into position.

  1. Start the engine and make sure that the vehicle moves forward after moving the shift lever from N to D and moves rearward after moving the shift lever to R.
    If the operation cannot be performed as specified, inspect the park/neutral position switch assembly and check the shift lever assembly installation condition.



4. INSTALL CONSOLE BOX ASSEMBLY
(Click here)