Home › SECURITIES › THEFT DETERRENT › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > Security Indicator Light Circuit


DESCRIPTION

  1. When the theft deterrent system is in the disarmed state, the security indicator will flash continuously if the immobiliser system is set, or not illuminate if the immobiliser system is not set.
    When the theft deterrent system is in the armed state, the immobiliser system is automatically set and the security indicator will flash continuously.
    When the theft deterrent system is in the arming preparation state and alarm sounding state, the main body ECU causes the security indicator to be illuminated.

WIRING DIAGRAM


B160793E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (SECURITY INDICATOR)
  1. Operate the Techstream according to the steps on the display and select "Active Test".

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Security Indicator
    Security indicator
    ON/OFF
    -

    OK:
    Security indicator illuminates.



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (COMBINATION METER - MAIN BODY ECU)

B354946E01

  1. Disconnect the J1 main body ECU connector.

  1. Disconnect the J28 combination meter connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    J28-37 (LP) - J1-4 (IND)
    Always
    Below 1 Ω
    J28-37 (LP) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE COMBINATION METER ASSEMBLY
  1. Temporarily replace the combination meter assembly with a new or normally functioning one (Click here).

  1. Check security indicator light.

    OK:
    Security indicator illuminates.



NG
REPLACE MAIN BODY ECU
OK

END (COMBINATION METER WAS DEFECTIVE)